ROCKARMOR GT HOOPLESS BULLBAR TO SUIT MAZDA BT50 2020+ (Full Bar Replacement) FITTING VIDEO BELOW Fit: Full Bumper Replacement (Factory Grille Cut)  THE ROCKARMOR GT BULL BAR  Designed locally in Australia, Rockarmor's all new GT Bull Bar comes with a whole new look, suited towards today's late model vehicles,  that require maximum protection, while complementing your vehicle's factory aesthetics. As well as offering your BT-50 with maximum frontal protection, The Rockarmor GT bull bar has been designed to improve your Mazda's off road experience with a number of features that include, higher approach angles, facilities for off road recoveries, and provisions for vital accessories that includes, electric winches, driving lights & uhf communication.   The full bumper replacement Steel bull bar comes packed with a number of beneficial features, which include 51mm Tubing, twin slotted antenna mounts, bash plates, Led Fog lights & Indicators, as well as provisions for high lift jack use, winch and driving lights & and Rockarmor all new soft shackle friendly rated recovery points.  The Rockarmor GT Bull Bar, has been engineered to be compatible with your vehicle safety features which include factory air bags & bumper sensors. The bull bar is finished in a highly durable black powder coat finish, Optional colour matching is available through your local Rockarmor Distributor.  Features & Specifications:  Built in 3.2Tonne Rated Recovery Points (Each recovery point) *Soft Shackle Compatible)  51mm Top cross tube for maximum frontal protection Durable 2.8mm High Quality steel construction for maximum protection Designed for high approach angles (great for offroad)   Built in LED FOG lights & LED Indicator, compatible with factory controls Extended Silver Centre Bash Plate (Protects Front)   ADR Complied Air bag compatible mounting system Factory Sensor Compatible  Side under Protection panels Included Twin Slotted Antenna Mounts located on top Cross Tube Twin Hi-Lift jack points  Front Protection Buffers Accommodates an electric winch up to 12,000 pound (Built in winch plate)  Laser cut mounting holes to accommodate 2 x 9" LED Driving Lights Shot blasted, Chemical Washed (for extra protection against rust) Finished off in a high quality black powder coat finish FITTING OF BULLBAR To comply with NZTA all daytime running lights should be installed separately to your headlights. Also note that the fog lights need to be adjusted to three degrees down. If your vehicle's suspension is not upgraded to withstand 60-100kgs, we do recommend that you upgrade the suspension, especially in the front of the vehicle to withstand the weight of the Steel Bumper & optional winch (if an electric winch is installed with the bull bar) If your vehicle's suspension is not upgraded, or if you are running factory suspension, your front suspension will sag and the ride will become bumpy which can possibly lead to further damage.  We recommend when fitting the bull bar to leave a minimum 10-15mm gap between the bullbar and body of the vehicle. This will allow for movement where the chassis & body move independently.    FITTING VIDEO